Wrong data from Fronius Symo

Problems Fixed
#1

Hello all,
I have some strange error with the data from my Fronius Symo inverter.
When I look at the web interface of the inverter is say that I have produced one figure (today 24.234 kWh).
When I look ta Pvoutput it reports that I have produced much more (25.932kWh).
Earlier when i checked this the figures has been the same. I think this difference started for about one month ago but I am not sure when.
Se screenshots from today.
bild

I use Fronius Push-service to send data to PVOutput, I have not changed any settings.

Dos anyone know what the problem are and how I shall do to get i correct again?

#2

i have had that too, its when my inverter shuts down completely and then restarts as i high voltage or very heavy rain for more than 20 min. its as it has started a new day again on the same day, although i see that the total life KW produced on my inverter is correct—so i just fix up manually the total on pvorg ,it has happened about 6=7 times in a year,also a inverter software update will do the same when it restarted the inverter

#3

Energy values are now calculated by default due to Fronius firmware issues.

The inverter’s reported energy can be used by adding &dayenergy=1 to the push config.

#4

How do I do to fix/change the push config?

After I did this report it looked like the result was correct but today when I checked it was a big difference again.

#5

See the above post, add &dayenergy=1 to the inverter push config.