https://pvoutput.org/compare.jsp?sid=52943&sid1=21873
If I compare data from my installation it shows different amount.
Site Yingli collects data from Flukso and a DinRail meter the total amount, East & West from Solaredge with an API key.
From 11/07/17 there is a difference between de two.
Please advice to solve this problem
Kind regards Ron
One is logging from solaredge while the other is using flukso.
The difference in numbers would be due to the data reported by each system.
PVOutput does not change the data from either systems unless there has been a rule applied.
You will need to determine which system has the accurate data and then investigate why the other system reporting different numbers.
According to data from the Solaredge portal the data from Flukso seems to be accurate its a bit lower but that’s normal.
33.876 kWh Solaredge Portal
33.145 kWh Pvoutput with Flukso
27.049 kWh Pvoutput With Solaredge API
on 17/07/17
As you can see as of 11/07/17 there’s a difference between the two, I did not Change anything in the settings.
Can an will you look into the data Solaredge is sending to PVoutput, the Solaredge data is from two Inverters who are conneted with RS 485.
Kind regards Ron
Thanks for clarifying - the solaredge should more be more closer to the flukso reading now.
Thanks,
I can see the difference
What has changed on the side of Pvoutput since 11-7-2017