I’m trying to save extended data graph set up, but it just won’t stick. It was working with five extended parameters, but now I can’t get it to work with the original config, or desired new config.
https://pvoutput.org/intraday.jsp?sid=6943
The graph axis parameter isn’t being saved, or, on occasion, is being saved as something other than entered. At one point I went back in to edit, and all parameters that were saved on axis zero showed axis three.
I’ve just reproduced that - I tried setting v9 to axis 1, and v11 to axis 2, and saved. It now will not display any charts at all under live data, and if I go back into the config, I get this (parameters that were on axis 0 have jumped to axis 5, and parameters that were on anything other than axis zero are reset to axis zero)
This is the config that I used to have, which worked fine.
I added another parameter - forecast solar - and set it to axis 0 along with all the other power parameters, W to kWh summary, and saved.
However when I tried to review the graph, I couldn’t see v9 (state of charge) and v11 (Battery Voltage) was a flat line on the chart. v9 was sqashed to the zero load axis.
When I went back to edit the config, I could see that all extended parameters were on the zero axis again.
I tried just changing one item - axis for v9, and saving, but that didn’t stick either.
